Your Best Choice for Furnace Repair and Air Conditioner Repair in Howell MI (49)

Did a furnace and AC tune up I cleaned the condenser coil tested the startup components, checked the refrigerant charge. I changed the air filter cleared the drains and all hoses inside the furnace tested the ignitor and all limits and safeties. Cleaned the burners and flame sensor ran a combustion analysis and both units are operating properly at this time

Amana air conditioner tune up

Kenmore air conditioner repair

Diagnosed fan issues on a carrier furnace.

Repair connections at outdoor disconnect.

Installation of return air duct to lower level.

Installation of high efficiency el16 lennox air conditioner with dte rebates

Installation of a sl280 furnace and xc13 air conditioner with a icomfort t-stat

Lennox high efficiency slp98 furnace and lennox air conditioner install

No heat call. High limit switch tripped due to clogged air filter. Replaced air filter, unit started and had a low flame sense code recommend cleaning flame sensor or replacement and customer told me to replace it. Replaced flame sensor tested all limits and safeties unit starts and runs well at this time.

Replace bad blower motor on a comfotmaker funace

Replace comfortmaker inducer assembly.

Repair veisman gas boiler

Did a double furnace tune up on two Bryant 350mav I checked the thermostat batteries and air filters changer the water panel and tested the humidifier operation and drain and cleared all hoses and drains on both cleaned the burners and flame sensor and tested the ignitors and all limits and safeties ran a combustion analysis and both units are operating properly at this time

Repair Amana furnace. Perform annual maintenance time up.

Repair Lennox high efficiency gas furnace.

Installation of a Lennox slp98 furnace and a Lennox 13acx air conditioner with a s-30 thermostat

Installation of 40 gallon state water heater

Installation of a Lennox oil furnace with a aprilaire air cleaner and t-star

Did a no heat call. Diagnostic code said ignition fault. Had power to the ignitor tested ignitor. Ignitor failed. Replaced ignitor. Tested all limits and safeties. Unit starts and runs properly at this time

No heat call on a carrier 58pav. Diagnostic code throwing an ignition fault had power to the ignitor, tested the ignitor. Ignitor failed. Replaced ignitor tested all limits and safeties unit starts and runs properly at this time.

Lennox furnace installation with aprilaire air cleaner and programmable 8463 thermostat.

Did a furnace tune up on a Lennox slp98, homeowner does humidifier and air filter maintenance, thermostat does not require batteries, cleared drain and all hoses inside the furnace, tested the ignitor and all limits and safeties, cleaned the burners and flame sensor. Ran a combustion analysis and this furnace is operating properly at this time

Installation of lennox high efficiency slp98 furnace and 16 seer el16 air conditioner

Installation of lennox automatic hcwb3-17a humidifier