Your Best Choice for Furnace Repair and Air Conditioner Repair in Howell MI (46)

Performed comprehensive preventative maintenance on a Dunkirk boiler cleared and cleaned the pilot orifice and cleaned off the burners and flame sensor, tested the spark ignition system, expansion tank, each zone valve, the relief valve. Checked the circulator pump amp draws, and ran a combustion test and let the unit cycle. This unit starts and runs properly at this tim

Bryant furnace tune up

Consumers rebate tune up

State water heater installation.

Lennox ML180 furnace tune up

Lennox ML180 furnace tuneup.

Performed comprehensive furnace maintenance on a Lennox el296 I replaced the air filter and water panel cleared all drains and hoses inside the furnace tested the humidifier ignitor and all limits and safeties cleaned the burners and flame sensor and ran a combustion test. This unit starts and runs properly at this time

Performed utility diagnostic furnace maintenance, I checked the air filter replaced the water panel tested the humidifier ignitor and all limits and safeties, cleared all drains and hoses inside the furnace cleaned the burners and flame sensor checked the inducer and blower motor amp draws, ran a pre and post service combustion test. I adjusted the gas pressure due to unit being under fired and retested. This unit is operating properly at this time

Performed utility comprehensive maintenance I replaced the air filter and humidifier pad, cleared all the drains and hoses inside the furnace tested humidifier ignitor and all limits and safeties cleaned the burners and flame sensor and ran a combustion test and this unit starts and runs properly at this time

Annual furnace maintenance tune up. Change filter and humidifier panel. Combustion test.

Lennox furnace tune up

Lennox O23 oil furnace tune up

Weil-mclain gas boiler tune-up

Lennox oil furnace tune up

Performed advanced utility diagnostic furnace maintenance, I checked the air filter replaced the water panel, supplied by homeowner, I cleared all the hoses inside the furnace tested the ignitor humidifier and all limits and safeties. Cleaned the burners and flame sensor and ran a combustion test and this unit starts and runs properly at this time

Performed advanced furnace and A/C maintenance I cleared all the drains and hoses inside the furnace tested the humidifier ignitor and all limits and safeties. Replaced the humidifier pad, cleaned the burners and flame sensor ran a combustion test. I cleaned the outdoor condenser coil tested the startup components and checked the amp draws on the compressor and condenser fan motor and checked the refrigerant charge and both units start and run properly at this timw

Replace failed aquastat on a Utica oil boiler

Performed advanced maintenance on a furnace and A/C, I replaced the air filter cleared the condensate drain and all hoses inside the furnace tested the ignitor and all limits and safeties cleaned the burners and flame sensor and ran a combustion test. I cleaned the condenser coil tested the startup components and checked the refrigerant charge and both units start and run properly at this time

Did a furnace and a/c tune up I cleared all the drains and hoses inside the furnace homeowner does the humidifier and air filter maintenance I tested the ignitor and all limits and safeties cleaned the burners and flame sensor ran a combustion test I cleaned the outdoor condenser coil tested the start up components and checked the refrigerant charge and both units start and run properly at this time

Performed a furnace and AC tune up I replaced the air filter and humidifier pad, cleared all the drains and hoses inside the furnace tested the humidifier ignitor and all limits and safeties I cleaned the burners and flame sensor and ran a combustion test.i cleaned the outdoor condenser coil tested the startup components and checked the refrigerant charge and both units start and run well at this tim

Lennox high efficiency air conditioner install

Replace bad capacitor and adjust refrigerant charge.

Installation of a Lennox sl280 furnace with a i-comfort t-stat

Performed a furnace and AC tune up I checked the thermostat batteries replaced the air filter, cleared the condensate drain, and all hoses inside the furnace, tested the ignitor and all limits and safeties cleaned the burners and flame sensor and ran a combustion test, I cleaned the outdoor condenser coil tested the start up components and checked the refrigerant charge and both units start and run well at this time

Replace seized blower motor